Stoppers
The current ANTAL range of stoppers comes in 4 different models supplied in single, double and triple versions. As well as the new CAM 611, there are three models: V-GRIP, V-GRIP Plus and Maxi; these are fitted with the ingenious “V” shaped cam that increases the bearing surface on the line and consequently gives higher working loads.
The new "V-Grip" Stopper is designed to provide high holding power with no line slippage while allowing the line to be released under maximum load without the use of a winch. The line can also be tailed through the stopper without opening the cam mechanism.
CAM 611: ROPE CLUTCH is a new model for line 6 to 11 mm, available in single, double and triple, as well as horizontal.
"V-Grip" Stopper is designed to provide high holding power with no line slippage while allowing the line be released under maximum load without the use of a winch.
Stopper Deck Block range of 65, 80, 100, 125 mm sheaves. The sheaves are made of high strength resin, fitted with composite fibre bush and side ball-bearings. No maintenance or lubrication is required.
Antal "halyard slider" has been specifically planned for wire halyards and for those halyards which are subject to such high strain as to preclude use of a stopper. This solution permits easy adjustment and secure locking of halyards. Especially good for furling halyards.
For Stopper Selection see table below
Technical Sheets
 |
CLUTCHES CAM 611 Acrobat PDF File | Size: 1.19Mb | Click here to download |
|
CLUTCHES - V GRIP Acrobat PDF File | Size: 226k | Click here to download |
|
STOPPER DECK BLOCK Acrobat PDF File | Size: 206k | Click here to download |
|
HALYARD SLIDER Acrobat PDF File | Size: 111k | Click here to download |
|
STOPPER SELECTION GUIDE Acrobat PDF File | Size: 103k | Click here to download |
 To save the PDF to your computer, please right-click (PC) or control-click (Mac) the link on your mouse. Select the option to 'Save to...' |
|
